ยินดีต้อนรับสู่ ห้างหุ้นส่วนจำกัด เอ็ม.อี.พี. คอนโทรล

E Series End Suction Centrifugal Pump Din 24255

PUMP CONSTRUCTION
Electra E series fully comply to both dimension standards & performance for the International Standards DIN24255

1. Volute Casing
2. Impeller
3. Wear Ring
4. Shaft Sleeve
5. Support Foot
6. Bearing Housing
7. Bearing Housing
8. Stuffing Box
9. Shaft

DESIGN FEATURES
Operating Temperatures
With standard packed gland -10 ํC to + 105 ํC
Maximum with cooled stuffing box up to 160 ํC
With mechanical seal-maximum depends upon seal used

ELECTRA BACK PULL-OUT FEATURE
This design feature allows the complete rotating element to removed for sevicing without disconnecting pipework. If a spacer coupling is fitted then motor does not have to be moved. On re-assembly of pump coupling re-alignment problems are completely eleminated.

OPERATION PRESSURE
Maximum operating pressure 1600kPa.
Maximum test pressure up to 2100kPa.
(Maximum pressures will vary depending on particular pump model - higher ratings available on application.)

MATERIALS OF CONSTRUCTION

Casing

Cast Iron

Impeller

Bronze/Cast Iron

Wear Ring

Cast Iron/Bronze

Shaft

Stainless Steel/High Tensile Steel

Shaft Nut

Bronze

Shaft Sleeve

Stainless Steel

Lantern Ring

Cast Iron

Gland

Cast Iron